Search results for "Hole-drilling method"
showing 5 items of 5 documents
Use of Hybrid Methods (Hole-Drilling and Ring-Core) for the Analysis of the RS on Welded Joints
2022
The hybrid methods (HMs) for the residual stress (RS) analysis, such as the well-known hole-drilling method (HDM) and the ring-core method (RCM), have been widely developed since 80’. They are mechanical methods based on the partial relaxation of the RSs that occur when a proper geometry variation of the analysed component is introduced by drilling a hole (HDM) or a proper annular groove (RCM). The RS computation is performed by measuring the strains relaxed on surface and then by combine properly such measured strains with the influence coefficients previously computed accurately by using a numerical codes that consider the geometry of the particular component to be examined. In such a man…
Dependence between aging treatments and residual stresses on composite laminate
2006
International audience; The objective of this paper is to study the influence of residual stresses due to fabrication conditions on the thermomechanical behavior of carbon/epoxy laminate structures (cross ply). These studied laminates have undergone various cycles of thermal aging. The addition of a post-cure cycle after the end of the initial cycle makes it possible to reduce the residual stresses level. The incremental hole-drilling method is used to measure the residual strain in the laminates. These measured strains and the numerical calibration coefficients obtained by the finite element method allow to calculating the residual stress distribution in composite depth. The obtained resul…
An analysis of through-thickness residual stresses in aluminium FSW butt joints
2006
Abstract In the paper, the results of a wide experimental campaign on friction stir welding (FSW) of aluminum alloys are reported. The attention was focused on the through-thickness residual stresses that occur on aluminum joints, after the welding process. In detail, using the hole-drilling method the residual stresses distribution in the zone close to the tool shoulder border of the joint advancing side, has been investigated; four different aluminum alloys and three different process conditions have been considered. The experimental analysis has shown that unlike traditional welding processes, the residual stresses are negative in the surface of the examined zone, and increase with depth…
RESIDUAL STRESS ANALYSIS OF ORTHOTROPIC MATERIALS BY THE THROUGH-HOLE DRILLING METHOD
2007
The present study deals with the development and the application of the through-hole drilling method for the residual stress analysis in orthotropic materials. Through a systematic theoretical study of the stress field present on orthotropic plates with a circular hole, the relationships between the relaxed strains measured by a rectangular strain gauge rosette and the Cartesian components of the unknown residual stresses are obtained. The theoretical formulas of each influence coefficient allow the user an easy application of the method to the analysis of uniform-residual stresses on a generic homogeneous orthotropic material. Furthermore, to extend the method to the analysis of the residu…
Investigating the effect of residual stress on hydrogen cracking in multi-pass robotic welding through process compatible non-destructive testing
2021
Abstract In this paper, the effect of Welding Residual Stress (WRS) on the size and morphology of hydrogen-induced cracks (HIC) is studied. Four samples were manufactured using a 6-axis welding robot and in two separate batches. The difference between the two batches was the clamping system used, which resulted in different amounts of welding deformation and WRS. The hydrogen cracks were intentionally manufactured in the samples using a localised water-quenching method, where water was sprayed over a specific weld pass in a predetermined position. The Phased-Array Ultrasonic Testing (PAUT) system was implemented during the welding process (high-temperature in-process method), to detect the …